If a product is unavailable online, please contact your local branch.
My Cart
 

FAQ

Elevate your pool and landscape experience: expert advice and solutions for seamless enjoyment.

Elevate your pool and landscape experience: expert advice and solutions for seamless enjoyment.

Pool Cleaners

Low pressure. Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Check the filter screen, located about 2ft from the wall fitting.  Inspect and clean.  If filter screen continually clogs, check pool...
Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Spinout check valve failed or debris is behind the check ball preventing full closure of the ball in check valve. Contact your Hayward Authorized Phantom dealer...
Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Gearbox failure.  Remove the cover and determine if red cam is moving during operation. Make sure all hoses are attached to the gearbox.  If not ...
Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Selector switch on gearbox may not be connected to external slide switch. Open cleaner and reconnect.  Contact your Hayward Authorized Phantom dealer ...
Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Selector switch on the gearbox may not be connected to the external slide switch. Open cleaner and reconnect or contact your Hayward Authorized Phantom dealer...
Use pressure-testing fitting to check the pressure. It should be approximately 27psi.  Selector switch on the gearbox may not be connected to the external slide switch. Open cleaner and reconnect or contact your Hayward Authorized Phantom dealer...
Selector switch on the gearbox may not be connected to the external slide switch. Open cleaner and reconnect or contact your Hayward Authorized Phantom dealer for repair.  The Upper thrust jet hose maybe disconnected at the manifold or Jet. &...
One or more of the skim jet hole/s maybe clogged.  Contact your Hayward Authorized Phantom dealer for repair.  Check all hose connections for possible leaks.  Ensure o-rings at rigid pipe connections are in place and not damaged. &nbsp...
Hose length is incorrect.  Adjust hose to required length using the measuring tape included with the cleaner.  In Pools with a steep slope, it is better to use a cam with the next lower number of prongs (less frequent Spin-Outs) in order...
Spins-out is too frequent. Change the Spinout cam to a setting lower than what is presently being used.   Keep adjusting cam setting until the cleaner is able to reach the furthest end of pool. 
Hayward suction cleaners depend on several factors to operate.
Perform the “Hang Test”. With the cleaner connected and running, hold the cleaner by the hose, below the water line.
Cleaner hoses when removed from the pool should not be coiled up for storage. If you have coiled them, take the sections apart and lay them straight in the sun.
Make sure the cleaner has the appropriate cork “shoes” and they are not worn.
The hose might be too short. First, check to see that the hose extends two full sections past the furthest point in the pool.
The cleaner is heavier than water, and should not float. Ensure that all the air was removed from the cleaner head and hoses during installation.
Check the “shoes”, “wings” and “flaps” for wear.
The vacuum or flow setting is too high. Use the “vacuum gauge adaptor” or “flow gauge” supplied with the cleaner to measure the vacuum in the cleaner hose. You should have 1" vacuum per section of hose.
Check the shoes and replace if necessary. If the “shoes” are worn, the “pods” may need to be replaced. Periodically check the “shoes” and replace as necessary.
The top of the cleaner normally turns slowly.  If it can not turn, the “upper steering may need to be repaired or replaced. Consult your Authorized Hayward Dealer for assistance.